|
|
Diamond Saws > Model 1500HD – 14 SS
Description:
The Model 1500HD - 14 SS Precision
Abrasive Cutoff Saw
has become the standard against which others are measured. It is used by a diversity of companies requiring an accurate, reliable and profitable way to cut hard and brittle materials.
Features:
- Up to 14" [356 mm] diameter cut-off wheels on 3/4" arbor
- 4-1/2" [115 mm] cutting capacity
- Stainless steel superstructure
- Standard 3 HP, 3-phase motor
- Cartridge type spindle
- Labyrinth sealed against entry of dirt, grit and water
- Alignment 0.001" [0.025 mm] TIR on squareness of spindle with table travel
- Precision parallel ground 4-5/8" [117 mm] diameter stainless steel wheel flanges
- Angular contact high precision bearings (ABEC 5 grade)
- Life-time factory lubrication
- Spindle lock for easy wheel changes
- Work light mounted on spindle housing with internal wiring
Options:
- Spindles: from utility grade to highest precision machine tool grade
- Table mounted inertial mass to reduce chatter on tough materials
- Electric motors: from 1 HP to 5 HP (larger on request)
- Power feed units: electronic, electric, pneumatic, hydraulic (PF 20 air/hydraulic system shown above)
- Fresh water to drain coolant systems
- Through spindle coolant system
- Ported wheel flanges direct coolant into wheel/work interface
- Hollow stainless steel spindle with durable rotary seal
- 300 GPH pump with all plumbing installed
- Operator adjustable flow control located on machine front
- Easily serviceable, non-clogging design
- Heavy duty welded stainless steel settling tank incorporated into enclosed machine base with 1-1/2" pipe drain opening
- Table 1" thick, flat ground, hard-coated aluminum with T-slots
- Cutting fence of hard-coated aluminum equipped with adjustable work stops and splash shield
- Precision linear ball bearings riding on 1" diameter hardened stainless steel guide bars and protected with sealed neoprene rubber boots
- Removable cast aluminum wheel guard
- Long work support fixtures
- Special gang wheel spindles and guards
- External coolant system available
- Semi- and fully-automatic operation
- Custom fixturing and tooling
|
| |
|
|
|
DYNACUT, INC.
3425 Funk Mill Road, P.O. Box 156, Springtown, PA 18081
Phone: 610-346-7386 • Fax: 610-346-6770 |
 |
|
|
 |
|
